[3D printed pieces] 3D printed pieces for Ξ GUNDAM Shoulder expansion parts and cockpit opening parts.

Shoulder expansion parts need to prepare 1mm glue sticks by yourself.

Cockpit opening parts.
HG 1/144 scale Xi Gundam cockpit. It consists of 13 separate pieces with top closing switch. Extend the connecting rotating shaft for easier fixation. It adopts magnetic opening & closing design, with appearance almost identical to the original version.
Newly added waist and chest modification parts come with spherical cockpit, aisle and bridge interior details. This design sacrifices waist articulation. It is recommended to glue the joint between waist and chest after painting to eliminate loose gaps.
Internal structure of rear chest armor needs modification.
Layer lines are inevitable on 3D printed parts, certain modeling skills are required.
Compatible with both JJ and Bandai Xi Gundam kits. For JJ version, sand the straight waist connecting pegs (its connecting holes are 0.2mm smaller than Bandai’s, polish pegs with sponge sandpaper). The bridge holes are relatively narrow; stretch runner scraps for assembly.
These are resin 3D printed parts, coloring is required by yourself.
Please prepare 1mm & 0.5mm glue sticks or copper rods in advance. Since the waist connection structure is redesigned, 2mm glue sticks are also needed.

It takes about 2-3 weeks for 3D printed parts to be shipped. 3D printed items cannot be returned or cancelled.

Important for printed parts:
• Never soak in water! 
• Never oven-dry! 
• This is a universal precaution for all printed parts worldwide.

Avoid water immersion as their structure can trap moisture. If accidentally soaked, ensure complete natural air-drying for at least 24 hours. Similarly for drying - excessive heat may increase the risk of cracking.